ALG Defense Quality Mil-Spec Trigger QMS

Experience a smooth trigger pull without the grittiness of a stock trigger with the ALG Defense Quality Mil-Spec Trigger QMS 05-198.It is close to mil-spec standards and conforms to most trigger pull weight regulations. Typically, the trigger pull averages about 6.5 pounds, which is well below the 9.5 pound limit. The ALG Defense Quality Mil-Spec Trigger QMS 05-198 breaks crisp and clean while retaining stock trigger reliability. Customize your weapon with the ALG Defense Quality Mil-Spec Trigger QMS 05-198. Specifications for ALG Defense Quality Mil-Spec Trigger QMS: Manufacturer: ALG Defense Trigger Material: 8620 Steel Trigger Pull Weight: 6.5 lb Condition: New Features of ALG Defense Quality Mil-Spec Trigger QMS 05-198: Performance Advantages for the Shooter Smoother than a stock trigger because sear surfaces are honed smooth without removing metal below the valleys of the stock surface finish Sear geometry has not been changed from standard so the high reliability that the stock trigger is known for is unchanged Trigger and hammer are made from true 8620 alloy steel military specification castings, correctly carburized, quenched and tempered for high surface hardness Disconnector is 1070 High Carbon steel properly Austempered into the spring range of hardness Springs are corrosion resistant and meet military specifications. A full force hammer spring is used for positive ignition of all type of ammunition. Trigger and hammer pins are improved over stock mild steel by using 4140 Chrome-Moly steel that has been quenched and tempered. Pins are centerless ground to a fine finish and a diameter 0.001 inch larger than stock to reduce play in the trigger assembly while retaining a slip fit into the weapon lower receiver. Pull weight is above the US Military minimum pull weight of 5.5lbs but does not reach near the upper limit of 9.5lbs. Generally, the pull weight is about 6.5lbs. Advantages for the Armorer Enhanced standard trigger so maintenance and installation procedures are unchanged Spare parts commonality with stock triggers Trigger assembly parts may be interchanged between triggers, there are no matched sets Since it is a trigger meeting the US Military trigger specifications for the M4 Carbine, it can be substituted for lower performing stock triggers while still staying in compliance with Unit or Departmental requirements Package Contents: ALG Defense Quality Mil-Spec Trigger QMS 05-198